I have some problems with Autocrafting in Applied Energistics 2.
In general everything works fine, but in my crafting terminal there only show up half of my patterns. I connected everything fine and there are more than enough channels for the Modular Assemblers (due to Dense Me Conduit's). My CPU's are also connected and all the assemblers are online. But still only 2 of 4 get shown in the Terminal.. I tried replacing them but without success. Pls help me!!
I created a short Vid for better understanding if needed:
The problem was a connection to an ME Glas Cable with only 8 slots. It got prefered over the dense conduit so there weren't enough ports for the Interfaces. Thats why you should use dense smart cables on your controller to overwatch port usage =)
Hi there,
I have some problems with Autocrafting in Applied Energistics 2.
In general everything works fine, but in my crafting terminal there only show up half of my patterns. I connected everything fine and there are more than enough channels for the Modular Assemblers (due to Dense Me Conduit's). My CPU's are also connected and all the assemblers are online. But still only 2 of 4 get shown in the Terminal.. I tried replacing them but without success. Pls help me!!
I created a short Vid for better understanding if needed:
https://drive.google.com/open?id=1u6HXYrXGKjgRSrFA-2mPkIyHVPXI9EEo
Best regards,
Jon
If someone cares:
The problem was a connection to an ME Glas Cable with only 8 slots. It got prefered over the dense conduit so there weren't enough ports for the Interfaces. Thats why you should use dense smart cables on your controller to overwatch port usage =)