So, after watching Direwolf's video today I went ahead and set up a Deep Resonance smelter like he did. One RF Tools Liquid Monitor near the lava tank under the smelter, a Refined Storage exporter, in liquid mode, exporting lava, and set the monitor to put out a signal when the tank dropped under 41%. One small problem. It doesn't export a consistent amount of lava. Initially it filled the tank to 7 buckets, when it dropped down to 6.4 buckets it filled it to 8.4 buckets, next time it dropped to 6.4 buckets it filled it to 9.4 buckets, next time 8.4 buckets, etc, always importing 1 to 3 buckets (so far) on each trigger. Now 9.4 is kinda pushing it, the DR smelter needs between 40% and 60%, that's 6.4 buckets to 9.6 buckets. So I am a hairs breath from going too low and going too high, if it hiccups and puts in 10.4 the quality of the Resonating Crystal Liquid will drop. How do I make this more consistent?
So, after watching Direwolf's video today I went ahead and set up a Deep Resonance smelter like he did. One RF Tools Liquid Monitor near the lava tank under the smelter, a Refined Storage exporter, in liquid mode, exporting lava, and set the monitor to put out a signal when the tank dropped under 41%. One small problem. It doesn't export a consistent amount of lava. Initially it filled the tank to 7 buckets, when it dropped down to 6.4 buckets it filled it to 8.4 buckets, next time it dropped to 6.4 buckets it filled it to 9.4 buckets, next time 8.4 buckets, etc, always importing 1 to 3 buckets (so far) on each trigger. Now 9.4 is kinda pushing it, the DR smelter needs between 40% and 60%, that's 6.4 buckets to 9.6 buckets. So I am a hairs breath from going too low and going too high, if it hiccups and puts in 10.4 the quality of the Resonating Crystal Liquid will drop. How do I make this more consistent?