I'm basically looking for a way how to make a single water source block to pour down multiple channels and i'm not quiet sure how to do it, could I get some advice?
The best way to split a stream is to have the water fall down onto a single block with two sides dropping off of that block.
side view:
[] [] [] [] [] []
[] [] [] [] [] []
[] [] [] []
Water will split into multiple channels when the exit or drop to the next levels are the same number of blocks from the source block. If the design is going to carry over more than 7 blocks, you will need to include a drop in level.
Edit: Similar to this design, to avoid confusion.
Channel
https://www.youtube.com/user/Tyken132
My Blog/Forums
http://tyken132.com/
= place where water need to drop one block
= source block of water
Channel
https://www.youtube.com/user/Tyken132
My Blog/Forums
http://tyken132.com/
read my post.
Just put water in and it will split to differrent channel, but you can have one source block go farther than 7 block that's all.
Channel
https://www.youtube.com/user/Tyken132
My Blog/Forums
http://tyken132.com/
side view:
[] [] [] [] [] []
[] [] [] [] [] []
[] [] [] []
by c0yote
I tried it with terrible results. I gave my wife my glasses for a second, a creeper showed up and now my wife is pregnant.
Stupid 3D..