Hey, I made a swimming pool and the water isn't normal. Like it's got currents going in different directions instead of being flat. How would I make it flat and no currents.
guys, that doesn't work it creates a downward pull! you must make an image on how to not have a downward pull
If you do it correctly with the diagonal pattern the source tiles will propagate throughout the surface; so no, there will not be downward flow. Flow only happens if you have non-source tiles somewhere when you remove the dirt layer.
To avoid a downward pull, the whole volume has to be source blocks.
One way to get that is to fill the bottom layer with dirt except for holes along the diagonal, then put a source block in each hole, then build that pattern on each layer above it, and then remove the holes from the top down.
Picture:
IP: 108.170.46.83
I am here for you, Don't be afraid to send me a message.
Moat, pool, same difference.
Ninja. D:
Ceci n'est pas une signature.
removed shameless advertising :smile.gif:
I am here for you, Don't be afraid to send me a message.
IP: 108.170.46.83
edit: damn ninjas went back in time!!!
Added lens flare.
Credit to zaks88
If you do it correctly with the diagonal pattern the source tiles will propagate throughout the surface; so no, there will not be downward flow. Flow only happens if you have non-source tiles somewhere when you remove the dirt layer.
Ceci n'est pas une signature.
One way to get that is to fill the bottom layer with dirt except for holes along the diagonal, then put a source block in each hole, then build that pattern on each layer above it, and then remove the holes from the top down.
ROFL